Which Steel for Seawater?

Nov 17, 2026

Leave a message

The most common mistake in seawater material selection is assuming any stainless steel resists seawater. In fact, 304 and even 316 fail by pitting and crevice corrosion in marine service. Seawater contains about 3.5% salt, and high chloride levels plus flow, temperature and biofouling make corrosion far more complex than in fresh water. The goal is not the "most corrosion-resistant steel," but the material with acceptable corrosion rate and lifecycle cost for the specific condition.

  • Carbon steel + coating + cathodic protection: the workhorse for large structures

Most seawater steel is actually carbon steel (Q235, Q345) with heavy-duty coating and cathodic protection-used for platform jackets, dock piles and subsea pipelines. Uniform corrosion runs about 0.1–0.2 mm/year, so coating alone is insufficient; sacrificial anodes or impressed current are required. Mature and cost-effective, but needs short maintenance cycles. Suits large fixed structures where weight is not critical and periodic maintenance is allowed.

  • 316L: only for specific conditions, not general use

Molybdenum gives 316L better pitting resistance than 304, but pitting and crevice corrosion remain a risk in stagnant or low-flow seawater, especially above 40°C or where deposits and crevices exist. It suits high-flow, low-temperature, deposit-free piping and pump/valve parts with smooth surfaces and passivated welds. Long-term immersed tanks and static seawater lines should not use 316L. Bolts in splash zones have failed by crevice corrosion.

  • Duplex 2205: cost-effective choice for seawater pumps, valves and piping

PREN about 35 (vs. ~25 for 316L), critical pitting temperature above 50°C, and yield strength roughly twice that of 316L. Suits seawater cooling lines, high-pressure pump casings, valve bodies and heat exchanger tubes. Limits: welding requires controlled heat input and phase balance, forming is harder than austenitic grades, and it is still not recommended for stagnant seawater or crevice-sensitive locations. In flowing seawater, 2205 is the economic midpoint between 316L and super grades.

  • Super duplex 2507 and high-Mo austenitic: fallback for severe conditions

For splash zones, hot seawater, CO₂/H₂S-bearing systems and long-life maintenance-free components, choose PREN ≥ 40 materials such as 2507 (PREN ~42) or 6%Mo austenitic (254SMO, PREN ~43). Higher critical pitting temperature and crevice resistance, but several times the cost of 316L and demanding fabrication. Upgrade only when the duty truly requires it-raising the grade without matching welding and design can introduce new corrosion risks at welds.

Selection logic: first ask whether periodic maintenance is allowed (if yes, carbon steel + CP); then whether the medium flows and whether crevices or deposits exist (avoid stainless in stagnant/crevice areas); finally match grade to temperature and PREN. There is no universal steel for seawater-defining the service condition matters more than asking "which steel."

Send Inquiry